Slopeify

Mississippi Retaining Wall Permit & Cost

Mississippi builds on the IBC/IRC (local adoption). Construction costs here run about 17% below the US average (cost index 0.83). The calculator below is pre-set to Mississippi.

Do you need a permit in Mississippi?

The model-code line is 4 ft: under IRC R404.1 / IBC §1807.2, a wall retaining more than 4 ft of earth needs an engineered design, and at any height when there is a surcharge (driveway, slope or structure). Most Mississippi building departments require a permit at the same point.

Thresholds are set locally. Mississippi delegates enforcement to city/county building departments, so always confirm with yours before you build.

Mississippi retaining wall cost

With a regional cost index of 0.83, a typical segmental block wall in Mississippiruns roughly $25 to $50 per square foot of wall face installed. Enter your dimensions for a full estimate and materials list.

Frost depth and footing in Mississippi

The typical frost depth in Mississippi is about 12 in. Per IRC R403.1.4 / IBC §1809.5 the wall's base must sit below the frost line, so bury the leveling pad at least 12 in below grade (or one buried course / 12 in minimum, whichever is greater). The calculator works this out for your exact wall height. Frost depth varies with elevation, so confirm the local figure with your building department.

This gravity wall works

A 2-ft base passes all three stability checks.

Minimum base width
2 ft
Bury base below grade (frost line)
12 in
Lateral earth pressure (EFP)
30 pcf
Total horizontal push
240 lb/ft
Overturning FS (min 2)
3.00
Sliding FS (min 1.5)
2.20
Bearing: max vs allowable
960 / 2000 psf
Resultant in middle third
Yes, no heel uplift
4′ H2′ base
A permit is likely, check locally
  • At 4 ft with no surcharge, many jurisdictions exempt the wall from a permit, but always confirm with your local building department, as some require one for any retaining wall.

Cost and materials

120 sq ft of face
Estimated installed cost
$2,988 to $5,976
MaterialQtyCostBuy
Retaining wall blocks126 blocks$680Home DepotAmazon
Cap blocks32 caps$212Home DepotAmazon
Construction adhesive5 tubes$37Home DepotAmazon
Crushed-stone leveling pad2 cu yd$83Home DepotAmazon
Drainage stone (¾" clean)5 cu yd$228Home DepotAmazon
Perforated drain pipe (4")33 ft$48Home DepotAmazon
Filter fabric180 sq ft$60Home DepotAmazon
DIY materials total$1,348

Estimates only. Installed cost is face area times a typical dollar-per-square-foot range for the chosen material, times a regional cost index. Get exact pricing from a local contractor.

Some product links are affiliate links. If you buy through them we may earn a small commission, at no extra cost to you. It never changes the quantities or prices we calculate.

Next step

Get it priced by local pros

You have the design and a budget range. The next step is a real quote. Compare vetted retaining wall contractors in Mississippi against the numbers above, so you know a fair price before anyone starts digging. It is free and there is no obligation.

We may be paid a referral fee by a matched pro. It never affects your price or our estimate.

Recommended next steps

  1. Excavate and compact a 6-inch crushed-stone leveling pad, then bury the base at least 12 in below grade, below the frost line for your state.
  2. Build to a 2-ft base width and batter the wall back into the slope.
  3. Install the drainage system: clean drain rock behind the wall, a perforated pipe at the base daylighted to a low point, and filter fabric.
  4. Backfill and compact in 6 to 8 inch lifts, and finish the grade so surface water runs away from the wall.
  5. Check with your local building department; a permit is likely for a wall this size.

Hire a retaining wall pro in Mississippi

Compare quotes from vetted Mississippi contractors and licensed engineers against the numbers above. It is free and there is no obligation.

Find a pro in MS

Other states